SOTA plus NPOTA on Signal Mountain (W7Y/TT-161)

Signal Mountain (W7Y/TT-161) is now my favorite spot in the Grand Teton National Park. The summit is well-marked on the Grand Teton NP map, on the east side of Jackson Lake. It has a paved road to the top and it provides excellent views of Jackson Hole and the surrounding mountains. Oh, and it’s a great location for ham radio.

On this summit, I did a combination Summits On The Air (SOTA) and National Parks On the Air (NPOTA) activation. Well, sort of. It turns out that when I packed for the trip, I included my usual SOTA gear, which is all VHF. For NPOTA, I loaded up my HF DXpedition gear that needs a pretty hefty power source. These means that the HF stuff uses my car battery, so it is not SOTA-compliant. Oh well.

img_1698
Bob K0NR works stations on 2m fm for a SOTA activation.

For the SOTA activation, I used the Yaesu FT-1DR and my 3-element Arrow yagi antenna to work a handful of stations on 146.52 MHz. I was a little concerned about finding enough stations listening on 52, but once again a little bit of patience payed off and I made my four QSOs.

img_1707
Bob K0NR using the “back of the SUV” operating position. The 20m end-fed half-wave antenna is supported by a SOTABEAMS pole.

Then I set up the NPOTA station to activate Grand Teton National Park (NP23). My equipment was a Yaesu FT-991 driving an end-fed half-wave for 20m from LNR Precision. I’ve tried a number of different portable antennas over the years but have found that a half-wave radiator up in the air is a pretty effective antenna. This could be a center-fed dipole antenna but that can be a challenge to support, depending on the physical location.

The end-fed half-waves (EFHW) from LNR Precision are easily supported using a non-conductive pole such as the 10m SOTABEAMS pole. The top two sections of the pole are too thin to support much of antenna, so I have removed them. This makes my pole about 9 meters in length which is still long enough to support a 20m halfwave.  (The antenna angles out a bit as shown in the photo but its pretty much vertical.) I attached the pole to a fence post using some hook/loop straps. I don’t fiddle with the length of the antenna, I just let the antenna tuner in the FT-991 trim up the match. This is the same configuration I used in Antigua (V29RW), where it worked great.

The FT-991 is a great little radio for this kind of operation. The SUV we were driving is not set up for HF operation so I just located the radio in the back of the vehicle and plopped down on a folding camp chair. For power, I clipped directly onto the vehicle battery with fused 10 gauge wires.

I started by making a few calls on 20m ssb. As soon as I was “spotted” on the usual web sites, I had a good pileup going. I worked 40 stations in about 40 minutes, so averaged one QSO per minute overall. Thanks to everyone that worked me; all contacts have been uploaded to Logbook of The World.

Oh, and it was a lot of fun.

73, Bob K0NR

6 Replies to “SOTA plus NPOTA on Signal Mountain (W7Y/TT-161)”

  1. Pingback: NPOTA: Grand Teton, Yellowstone and Rocky Mountain - The KØNR Radio Site

  2. Love your posts, Bob. Always good technical information, and the photos are always great too. I climbed up top on Signal Mountain a few years ago, and imagine my surprise to see dozens of folks walking around with hot coffee, many tourists from all around the world. And now you remind me of the road up the back side! I’ll be back again soon, as I’m the proud owner of a new FT-817ND… be talking w/ you soon! 😉

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.